Category: NTP applications

Configuring a Network to use a NTP Server Part two: Distributing the Time

  |   By

NTP (Network Time Protocol) is the protocol designed for time distribution amongst a network. NTP is hierarchical. It organises a network into strata, which are the distance from a clock source and the device.

A dedicated NTP server that receives the time from a UTC source such as GPS or the national time and frequency signals is regarded as a stratum 1 device. Any device that is connected to a NTP server becomes a stratum 2 device and devices farther down the chain become stratum 2, 3 and so on.

Stratum layers exist to prevent cyclical dependencies in the hierarchy. But the stratum level is not an indication of quality or reliability.

NTP checks the time on all devices on the network it then adjusts the time according to how much drift it discovers. Yet NTP goes further than just checking the time on a the reference clock, the NTP program exchanges time information by packets (blocks of data) but refuses to believe the time it is told until several exchanges have taken place, each passing a set of tests known asprotocol specifications. It often takes about five good samples until a NTP server is accepted as a timing source.

NTP uses timestamps to represent the current time the day. As time is linear, each timestamp is always greater than the previous one. NTP timestamps are in two formats but they relay the seconds from a set point in time (known as the prime epoch, set at 00:00 1 January 1900 for UTC) The NTP algorithm then uses this timestamp to determine the amount to advance or retreat the system or network clock.

NTP analyses the timestamp values including the frequency of errors and the stability. A NTP server will maintain an estimate of the quality of both its reference clocks and itself.

Reasons for Atomic Clock Timing

  |   By

Atomic clocks have, unbeknown to most people, revolutionised our technology. Many of the ways we trade, communicate and travel are now solely dependent on timing from atomic clock sources.

A global community often means that we have to communicate with people on other areas of the world and in other time zones. For this purpose a universal time zone was developed, known as UTC (Coordinated Universal Time), which is based on the time told by atomic clocks.

Atomic clocks are incredibly accurate, losing only a second in every hundred million years, which is staggering when you compare it to digital clocks that will lose that much time in a week.

But why do we need such accuracy in timekeeping? Much of the technology we employ in modern times is designed for global communication. The Internet is a good example. So much trade is done across continents in fields such as the stock exchange, seat reservation and online auctioning that exact time is crucial. Imagine you are bidding for an item on the Internet and you place a bid a few seconds before the end, the last and highest bid, would it be fair to lose the item because the clock on your ISP was a little fast and the computer therefore thought the bidding was over. Or what about seat reservation; if two people on different sides of the globe book a seat at the same time, who gets the seat. This is why UTC is vital for the internet.

Other technologies too such as global positioning and air traffic control are reliant on atomic clocks to provide accuracy (and in the case of air traffic is paramount for safety). Even traffic lights and speed cameras have to be calibrated with atomic clocks otherwise speeding ticket may not be valid as they could be questioned in court.

For computer systems NTP time servers are the preferred method for receiving and distributing a source of UTC time.

Computer Network Timing Solutions

  |   By

Computer networks and the internet have dramatically changed the way we live our lives. Computers are now in constant communication with each other making possible transactions such as online shopping, seat reservation and even email.

However, all this is only possible thanks to accurate network timing and in particular the use of Network Time Protocol (NTP) used to ensure all machines on a network are running the same time.

Timing synchronization is crucial for computer networks. Computers use time in the form of timestamps as the only marker to separate two events, without synchronization computers have difficulty in establishing the order of events or indeed if an event has happened or not.

Failing to synchronize a network can have untold effects. Emails may arrive before they are sent (according to the computer’s clock), data may get lost or fail to store and worst-of-all, the entire network could be vulnerable to malicious users and even fraudsters.

Synchronization with NTP is relatively straight forward as most operating systems have a version of the time protocol already installed; however, choosing a timing reference to synchronize to is more challenging.

UTC (Coordinated Universal Time) is a global timescale governed by atomic clocks and is used by nearly all computer networks across the globe. By synchronizing to UTC a computer network is essentially synchronizing the network time with ever other computer network in the world that uses UTC.

The internet has plenty of sources of UTC available but security issues with the firewall means the only safe method of receiving UTC is externally. Dedicated NTP time servers can do this using either long wave radio or GPS satellite transmissions.

Using Atomic Clocks to Synchronize a Network

  |   By

Most computer networks have to be synchronized to some degree. Allowing the clocks on computers across a network to all be telling different times is really asking for trouble. All sorts of errors can occur such as emails not arriving, data getting lost, and errors get unnoticed as the machines struggle to makes sense of the paradoxes that unsynchronized time can cause.

The problem is computers use time in the form of timestamps as the only point of reference between different events. If these don’t match then computers struggle to establish not only the order of events but also if the events took place at all.

Synchronizing a computer network together is extremely simple, thanks largely to the protocol NTP (Network Time Protocol). NTP is installed on most computer operating systems including Windows and most versions of Linux.

NTP uses a single time source and ensures that every device on the network is synchronized to that time. For many networks this single time source can be anything from the IT manager’s wrist watch to the clock on one of the desktop machines.

However, for networks that have to communicate with other networks, have to deal with time sensitive transactions or where high levels of security are required then synchronization to a UTC source is a must.

Coordinated Universal Time (UTC) is a global timescale used by industry all over the world. It is governed by a constellation of atomic clocks making it highly accurate (modern atomic clocks can keep time for 100 million years without losing a second).

For secure synchronization to UTC there is really only one method and that is to use a dedicated NTP time server. Online NTP servers are used by some network administrators but they are taking a risk not only with the accuracy of the synchronization but also with security as malicious users can imitate the NTP time signal and penetrate the firewall.

As dedicated NTP servers are external to the firewall, relying instead on the GPS satellite signal or specialist radio transmissions they are far more secure.

Using a NTP Server in your Network

  |   By

The Network Time Protocol server is used in computer networks all over the world. It keeps an entire network’s systems and devices synchronised to the same time, normally a source of UTC (Coordinated Universal Time).

But is a NTP time server a necessary requirement and can your computer network survive without one?  The short answer is perhaps yes, a computer network can survive without a NTP server but the consequences can be dramatic.

Computers are meant to make our lives easier but any network administrator will tell you they can cause an awful amount of difficulty when they inevitably go wrong and without adequate time synchronisation, identifying an error and putting it right can be nearly impossible.

Computers use the time in the form of a timestamp as the only reference they have to distinguish between two events. Whilst computers and networks will still function without adequate synchronisation they are extremely vulnerable. Not only is locating and correcting errors extremely difficult if machines are not synchronised the network will be vulnerable to malicious users and viral software that can take advantage of it.

Furthermore, failing to synchronise to UTC can cause problems if the network is to communicate with other networks that are synchronised. Any time sensitive transactions could fail and the system could be open to potential fraud or other legal implications as proving the time of a transaction could be near impossible.

NTP servers are easy to install and receive the UTC time signal from either long wave transmissions or the GPS satellite network which they then distribute amongst the network’s machines. As a dedicated NTP time server operates externally to the network firewall it does so without compromising security.

Does my Computer Network Need to be Synchronized to an Atomic Clock?

  |   By

Time synchronization with network time protocol servers (NTP servers) is now a common consideration for network administrators, although, keeping exact time as told by an atomic clock on a computer network is often seen as unnecessary by some administrators

So what are the advantages of synchronizing to an atomic clock and is it necessary for your computer network?  Well the advantages of having accurate time synchronization are manifold but it is the disadvantages of not having it that are most important.

UTC time (Coordinated Universal Time) is a global timescale that is kept accurate by a constellation of atomic clocks from all over the world. It is UTC time that NTP time servers normally synchronize too. Not just that it provides a very accurate time reference to for computer networks to synchronize too but also it is used by millions of such networks across the globe therefore synchronizing to UTC is equivalent to synchronizing a computer network to every other network on the globe.

For security reasons it is imperative that all computer networks are synchronized to a stable time source. This doesn’t have to be UTC any single time source will do unless the network conducts time sensitive transactions with other networks then UTC becomes crucial otherwise errors may occur and these can vary from emails arriving before they were despatched to loss of data.  However, as UTC is governed by atomic clocks it makes it a highly accurate and auditable source of time.

Some network administrators take the shortcut of using an internet time server as a source of UTC time, forgoing the need for a dedicated NTP device. However, there are security risks in doing such a thing. Firstly, the inbuilt security mechanism used by NTP, called authentication, which confirms a time source is where and who it claims it is, is unavailable across the internet. Secondly, internet time servers are outside the firewall which means a UDP port needs to be left open to allow the time signal traffic. This can be manipulated by malicious users or viral programs.

A dedicated NTP time server is external to the network and receives the UTC atomic clock time from with either the GPS satellite system (global positioning system) or specialist radio transmissions broadcast by national physics laboratories.

Time Synchronization Using the GPS Network

  |   By

The GPS (Global Positioning System) systems has revolutionized navigation for pilots, mariners and drivers a like. Nearly every brand new car is sold with an inbuilt satellite navigation system already installed and similar detachable devices continue to sell in their millions.

Yet the GPS system is a multi purpose tool thanks mainly to the technology it employs to provide navigational information. Each GPS satellite contains an atomic clock which signal is used to triangulate positioning information.

GPS has been around since the late 1970’s but it was only in 1983 that is stopped from being purely a tool of the military and was opened up to allow free commercial access following an accidental shooting down of a passenger airliner.

To utilise the GPS system as a timing reference, a GPS clock or GPS time server is required. These devices usually rely on the time protocol NTP (Network Time Protocol) to distribute the GPS time signal that arrives via the GPS antenna.

GPS time is not the same as UTC (Coordinated Universal Time) which is normally used  NTP for time synchronization via radio transmissions or the internet. GPS time did originally match UTC in 1980 during its inception but sine that time there have been leap seconds added to UTC to counteract the variations of the earth’s rotation, however the on-board satellite clocks are corrected to compensate for the difference between GPS time and UTC, which is 17seconds, as of 2009.

By utilising a GPS time server an entire computer network can be synchronized to within a few milliseconds of UTC ensuring that all computers are safe, secure and able to deal effectively with time sensitive transactions.

Dealing With Time computers synchronisation and timestamps

  |   By

Time is important for the smooth running of our day to day lives. Everything we do is either governed by or restrained because of time. Yet time is even more essential for computer systems as it is the only point of reference a computer has to distinguish between events and processes.

Everything a computer does is logged by the processor with what process was done and exactly when it was carried out. As computers can process hundreds if not thousands of transactions a second so the time stamp is vital for establishing the order of events.

Computers do not read and use the time in the same format that we do. A computer timestamp takes the form of a single digit that counts the number of seconds from a set point in time. In most systems this is known as the ‘prime epoch’ and is set from 00:00:00 UTC on January 1, 1970. So a timestamp for the date 23 June 2009 the timestamp would read: 1246277483 as this is the number of seconds from the prime epoch.

Computer timestamps are sent across networks and the internet, for instance every time an email is sent it is accompanied by a timestamp. When the email is replied to this too comes with a timestamp. Yet, when neither computer is synchronized the replied email could arrive back with an earlier code and this can cause untold confusion for a computer as according to its logs the email will have arrived back before the original was sent.

For this reason computer networks are synchronized to the global timescale UTC (Coordinated Universal Time). UTC is kept true by a constellation of atomic clocks which means that and computer network synchronised to a UTC source will be highly accurate.

Time synchronization on computers is dealt with by the protocol NTP (Network Time Protocol). Special dedicated NTP servers are available the receive a secure time code from either the GPS network or from specialist radio transmissions broadcast by national physical laboratories and then synchronize entire networks to the single time source.